Page 398 of 1566

Re: What did you do today?

Posted: Sun Jan 24, 2021 9:52 am
by Drum
I might be wrong, but I don't think Eddie has an Irish accent.

Re: What did you do today?

Posted: Sun Jan 24, 2021 11:22 am
by Hooli
He does now, I said so.

Re: What did you do today?

Posted: Sun Jan 24, 2021 7:48 pm
by cros
I was just going down the road when these jumped across in front of me. Only hares says Hooli.

Re: What did you do today?

Posted: Sun Jan 24, 2021 7:50 pm
by mercrocker
Impressive front lockage, there Cros!

Re: What did you do today?

Posted: Sun Jan 24, 2021 7:53 pm
by fried onions
Good old Bedford.

Re: What did you do today?

Posted: Sun Jan 24, 2021 8:01 pm
by Hooli
Big hares, little van...

Re: What did you do today?

Posted: Sun Jan 24, 2021 8:06 pm
by Hooli
I fixed the wiring on my throttle bodies, I cut the half snapped bit, soldered up, covered it with heat shrink tube & replaced the loom tape.
IMG_20210124_180039.jpg
IMG_20210124_180039.jpg (365.73 KiB) Viewed 2642 times
IMG_20210124_180604.jpg
IMG_20210124_180604.jpg (516.78 KiB) Viewed 2642 times
IMG_20210124_180944.jpg
IMG_20210124_180944.jpg (474 KiB) Viewed 2642 times
Then I got the broken idle adjuster off, it looks like it'd araldite ok once properly degreased. That's a 8mm spanner for scale.
IMG_20210124_192059.jpg
IMG_20210124_192059.jpg (682.99 KiB) Viewed 2642 times

Re: What did you do today?

Posted: Sun Jan 24, 2021 8:32 pm
by Eddie Honda
A cable place would do that no bother. It's like a speedo cable inner and their crimper will keep it on miles better than any Araldite.

Re: What did you do today?

Posted: Sun Jan 24, 2021 8:47 pm
by BenHar
mercrocker wrote: Sun Jan 24, 2021 7:50 pm Impressive front lockage, there Cros!
On the left, yes. Offside doesn't seem to be as good.

Lovely van though.

Ben

Re: What did you do today?

Posted: Sun Jan 24, 2021 8:50 pm
by BenHar
Hooli wrote: Sun Jan 24, 2021 8:06 pm I fixed the wiring on my throttle bodies, I cut the half snapped it, soldered up, covered it with heat shrink tube & replaced the loom tape.

IMG_20210124_180944.jpg
How did you get the heat shrink on?

Ben