Two wheels good.

[DodgeRover]

I would contact the importer, it sounds like you could have a stuffed battery pack with that little range, especially as the power is falling off. Lipo packs don't do that.

[Mike D]

I went and picked this up the other day, to get in on my very own HOT FRUNK ACTION I went for the DCT model in the end, hopefully this will be a good replacement for the nobber as a work bike

20240220_122330.jpg (961.34 KiB) Viewed 307 times

[Hooli]

I've had an amusing offer from HD to renew the warranty on Quinn for another year, at the bargain price of £451...

Considering they don't service it & refused the warranty claim for rust I put in at two weeks old, why do they think I'd bother?

[Jerzy Woking]

I went and picked this up the other day, to get in on my very own HOT FAKE TANK ACTION I went for the DCT model in the end, hopefully this will be a good replacement for the nobber as a work bike

20240220_122330.jpg

Aftermarket seat? Can't be worse than the standard one. Mine was dreadfully uncomfortable, but after my mods, it's good.

[Mike D]

Its a Shad gel seat, it came with the originals too. What mods did you do?

[Jerzy Woking]

2cm thick gel pad laid on the seat, with a sheepskin over the top. Usually I have just a sheepskin on my seats, but the NC needed the gel too.

[paulplom]

Really confident with the vespa now. Caught the side stand leaning on a left hander yesterday and nearly shit myself. Did it again today. Am I pushing too far?
Doesn't feel like I am.

[Jazoli]

You are probably leaning a bit much as the stand will lift the rear wheel off the ground eventually and you'll crash, especially if you hit a bump, best to hang off a bit but you'll look like a cunt hanging off on a scooter, I rode my daughters home from the shop in my race leathers and got my knee down a few times, on a pastel blue girly scooter

[Hooli]

I'd have paid to see that

[Hooli]

This happened while out today, it must be run-in by now?

PXL_20240224_143904212.jpg (551.15 KiB) Viewed 218 times

PXL_20240224_143930417.jpg (1.18 MiB) Viewed 218 times

Needs a wash and brake pads both ends for the MOT that's due next month. I might do that tomorrow and MOT it Friday as I'm not working.