What did you do today?

[Hooli]

Cleaned my workbench, tidied up and then polished my rod.

I would take a picture but I took it sideways and the forum now says error

I've tweaked it, want to try again?

[chadders]

I'm not certain that a picture of Phil's polished rod should be in the open part of the site.

[PhilA]

I'm not certain that a picture of Phil's polished rod should be in the open part of the site.

It was quite gratuitous.

20210104_204139.jpg (155.58 KiB) Viewed 148 times

That sort of worked... It ignored the metadata.

Phil

[Hooli]

There's no options for how it treats the metadata, I just set it to 1440x1440 rather than 1440x900.

That is a very shiney pole, does it still have the polish accent?

[SiC]

That's because it's dumbly stripping the metadata and not keeping the orientation data.

[PhilA]

There's no options for how it treats the metadata, I just set it to 1440x1440 rather than 1440x900.

That is a very shiney pole, does it still have the polish accent?

No, it was done quickly so it sounds Russian.

[AMCrebel]

20210104_204139.jpg (155.58 KiB) Viewed 142 times

[PhilA]

Just ordered a new master cylinder.
Going to try clean out the fuel pump and see if that helps any. I haven't touched it in 800+ miles, it's probably full of crap.

Then, I think I may try some ATF "improver", to try keep the viscosity up when it's hot. Issue isn't generally heat in the fluid but heat in the valve block.

Phil

[Drum]

Wasted an hour trying to get the polo's sump plug off. Who thought a 6mm allen key was a good idea for a sump plug? Tried various over sized torx and spline bits. Chisel and hammer wouldn't turn it. Ended up welding a chewed up 10mm drive torx bit to it.

I'll not miss working on it when the young un takes it back to uni on Thursday.

164000 miles though on the 1.2 three cylinder.

[Hooli]

Are yours allowed back? I thought uni was shut for now?